Guralp-systems CMG-3T Manuel d'utilisateur télécharger pdf (Page 44)

CMG-3T

The hybrid feedback circuit contains a single capacitor in parallel with

a resistor, resulting in a single dominant pole. Below this frequency,

which can be varied from the standard 30 seconds, the response of the

seismometer is flat to ground acceleration. Above it, the response is

flat to velocity. Hybrid-feedback systems provide a stable response,

particularly for portable systems, with a high saturation level at high

frequencies and a high dynamic range at long periods.

An active low-pass filter provides a high-frequency cut-off point at a

frequency you specify. Without the filter, the velocity response is flat

up to 100 Hz. Outside the feedback loop there is an active high-pass

filter with a corner frequency of 0.01 Hz (100 s) or 0.005 Hz (200 s),

which serves to remove any DC offsets.

Conventional-response feedback

44 Issue N

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 52 53

Pas de commentaire

Guralp-systems CMG-3T Manuel d'utilisateur Page 44